Looking for support for this cutter,
ive tried using the inkcut generic driver on the com port of the cutter and the software says its cutting but the machine isnt moving
so im confused as to why its not working
can anyone help me out here or anyone that has this cutter workling ?
thankyou
Hi Leroy. I was in the same position as you a while ago and just saw your question.
I'm using this configuration under the Configure Device option and it works fine:
Name: PixMac 720
Driver: Inkcut generic driver
Manufacturer: PixMax
Model: 720
Width: 600mm
When plotting I have to adjust the size of the work to be 122,4% of the original file.
Hope it helps.
IMHO "PIXMAX 720" is just the same as Refine MH720/721.
IIRC MH721 is listed within the plotter table and should be supported.