Not sure if anyone is able to assist...
I have installed Inkcut to run my old Creation Kcut vinyl cutter. After many hours of struggling, I got the machine to finally cut. But coming back to it again, it is doing the same thing as before. When I send to device, it just cuts a random wavy diagonal line. Occasionally it will cut correctly, but most of the time it just cuts the one random line.
The one time this morning that it did cut correctly, it started off fine, but then started moving in a slow, jerky manner as if lagging.
I am at wits end, and have no idea how to troubleshoot.
Is anyone able to advise how I can troubleshoot the problem?
Thanks
Josh